Ethernet Interface Configuration Commands - HP Procurve 2524 Cli Reference Manual

show interfaces
Displays the status and current configuration of all the switch ports.
Output Format:
Port
---- --------
1 10/100TX
2 10/100TX
3 10/100TX
4 10/100TX
5 10/100TX
6 10/100TX
7 10/100TX
8 10/100TX
9 10/100TX
10 10/100TX
2.8.2

Ethernet Interface Configuration Commands

To enter the Ethernet Interface Configuration level, use the Interface command described
above. Note that a port-list may be used to configure these options on more than one port
and that any of the following commands can be appended to the Interface command to
simply change the configuration. For example:
HP 4108GL(config)# interface ethernet A1,A3 disable
broadcast-limit <0..99>
Sets the theoretical maximum of network bandwidth in percentage that can be used
for broadcast traffic. Any broadcast traffic exceeding that limit will dropped. 0 means
the feature is disabled.
disable
Disables the port.
enable
Enables the port.
Status and Counters - Port Status
Intrusion
Type Alert
---------
No
No
No
No
No
No
No
No
No
No
Enabled Status
------- ------ ----------
Yes Up
Yes Down
Yes Down
Yes Down
Yes Down
Yes Down
Yes Down
Yes Down
Yes Down
Yes Down
Flow
Mode Ctrl
---------
Bcast
Limit
------
0
0
0
0
0
0
0
0
0
0
22