Led Mode Select Button And Indicator Leds - HP ProCurve 5400zl Installation And Getting Started Manual

LED Mode Select Button and Indicator LEDs

To optimize the amount of information that can be displayed for each of the
switch ports, the Series 5400zl Switches use a Mode LED for each port. The
operation of this LED is controlled by the LED Mode Select button on the
switch chassis, and the current selection is indicated by the mode indicator
LEDs near the button. Press the button to change from one mode to the next.
Mode LEDs
(one for each port)
Figure 1-6. Mode LEDs and LED Mode Select Button
Act
If the Activity indicator LED is lit, each port Mode LED displays
■
activity information for the port—it flickers as network traffic is received
and transmitted through the port.
FDx
■ If the Full Duplex
those ports that are operating in full duplex.
Spd
If the speed indicator LED is lit, the port LEDs behave as follows to
■
indicate the connection speed for the port:
• Off = 10 Mbps
• Blinking = 100 Mbps (the blinking behavior is a repeated on/off cycle
once every 0.5 sec.)
• On = 1000 Mbps
PoE
■ If the PoE indicator LED is lit, the Link and Mode LEDs indicate PoE
status:
Link LED:
• On = PoE is enabled on this port
• Off = PoE is disabled on this port.
Introducing the ProCurve Series 5400zl Switches
LED Mode Select button
indicator LED is lit, the port Mode LEDs light for
Front of the Switch
and indicator LEDs
1-9