Mazda Navigation system User Manual page 77

Band selection
n
Choose AM by pressing the
button.
The selected mode will be indicated. If FM stereo is being received, STEREO will be
displayed.
Tuning
n
The radio has the following tuning methods: Manual, Seek, Scan, Preset channel, and Auto
memory tuning. The easiest way to tune stations is to set them on preset channels.
Note
lIf the FM broadcast signal becomes weak, reception automatically changes from STEREO
to MONO for reduced noise, and the STEREO indicator will go out.
lPress the MAP button to switch to the map screen.
lIf the power supply is interrupted (fuse blows or the battery is disconnected), the preset
channels will be erased.
Manual tuning
n
Turning the TUNE dial will change the frequency higher or lower.
Seek tuning
n
Pressing and holding the SEEK/TRACK button (
higher or lower frequency automatically.
Note
If you continue to press and hold the button, the frequency will continue changing without
stopping.
Scan tuning
n
Press the SCAN button to automatically sample strong stations.
Scanning stops at each station for about 5 seconds. To hold a station, press the SCAN
button again during this interval.
Preset channel tuning
n
The 8 preset channels can be used to store 8 AM and 16 FM stations.
1.To set a channel first select AM, FM1, or FM2. Tune to the desired station.
2.Press the TUNE dial.
3.Select any channel preset on-screen button for about 2 seconds until a beep sound is
heard. The selected preset channel number and station frequency will be displayed. The
station is now held in the memory.
4.Repeat this operation for the other stations and bands you want to store. To tune one in the
memory, select AM, FM1, or FM2 and then press its channel preset button. The station
frequency and the channel number will be displayed.
Note
If the power supply is interrupted (fuse blows or the battery is disconnected), the preset
channels will be erased.
on-screen button and FM by pressing the
, ) will cause the tuner to seek a
on-screen
77