Philips PTV910 Service Manual page 28

- Line 4: NOT USED
- Line 5: "NO SIGNAL"
Indicates that the set is not receiving an "ident" signal on the selected source.
· no or bad antenna signal; connect a proper antenna signal
· antenna not connected; connect the antenna
· no channel / preset is stored at this program number; go to the INSTALL menu and store a proper
channel at this program number
· the tuner is faulty (in this case the CODES line will contain number 13 or 16); check the tuner and
replace/repair if necessary
Note: On some models, (if the BM option is ON), BLUE MUTE is displayed when no signal is
received.
- Line 6: "TIMER ON "
Indicates that the on/off timer is running.
The following Complaints may be caused by the activation of the sleep timer:
The set may turn on from standby or may switch to a different channel without using either the remote
control or the local keyboard.
To switch off the activation timer:
Select "TIMER" in the "FEATURE" menu.
Select "ACTIVATE' in the "TIMER" menu.
Set to "OFF" with the left/right cursor keys.
- Line 7: NOT AVAILABLE
- Line 8: "NOT PREFERRED"
Indicates that at least one channel is deleted as a preferred channel (by default, all channels are skipped.
Note that "SKIPPED" will always be displayed in CSM unless all the channels are not skipped.
To add a channel as a selected channel to the list of preferred channels:
Select "INSTALL" menu
Select "CHANNEL EDIT"
Select "ADD/DELETE"
Set to "ADD" with the left/right cursor keys
- Line 9: "HOTEL MODE ON"
Indicates that the Hotel mode has been activated.
- Line 10: "SOURCE:"
Indicates which SOURCE is installed for this preset.
EXT1, SVHS2, EXT2, Tuner.
- Line 11: "SOUND"
Indicates which sound mode is installed for this preset.
Mono, NICAM, Stereo, L1, L2, SAP, Virtual or Digital
- Line 12: "VOLUME"
Value indicates level at entry CSM.
- Line 13: "BALANCE"
Value indicates level at entry CSM.
7615 Adjustments page 14