Pride Quantum Q4 Owner's Manual page 18

V . C O M F O R T A D J U S T M E N T S
Seat Width Adjustment
You can adjust the seat width from 16 in. to 20 in.
(40.6 cm to 50.8 cm). See figure 14.
NOTE: Changing the armrest width may increase the
overall width of your power chair.
To adjust the seat width:
1. Remove the seat cushion.
2. Loosen the armrest receiver hardware.
3. Reposition the armrest receiver to the desired seat
width.
4. Tighten the armrest receiver hardware.
5. Adjust the width of the other armrest if necessary.
6. Replace the seat cushion.
Leg Rest Width Adjustment
You can adjust the leg rest width from 16 in. to 20 in.
(40.6 cm to 50.8 cm). See figure 15.
To adjust the leg rest width:
1. Remove the seat cushion.
2. Loosen the leg rest receiver hardware.
3. Reposition the leg rest receiver to the desired seat
width.
4. Tighten the leg rest receiver hardware.
5. Adjust the width of the other leg rest if necessary.
6. Replace the seat cushion.
Armrest Height Adjustment
You can adjust the armrest height. The height adjustment
range is 3 in. (7.62 cm) in 1-in. (2.54-cm) increments.
To remove the armrest assembly:
1. Pull out the armrest lock lever. See figure 17.
2. Lift up the armrest assembly.
To install the armrest assembly:
1. Place the armrest assembly into the armrest lock. See
figure 16.
2. Push in the armrest lock lever.
To adjust the top height:
1. Pull out the armrest lock lever. See figure 17.
2. Pull up or push down the armrest to the desired posi-
tion.
3. Push in the armrest lock lever.
4. Repeat for the other armrest if necessary.
18
Figure 16. Armrest Removal/Installation
ARMREST
LOCK
LEVER
Figure 17. Armrest Top Height Adjustment
www.pridemobility.com
ARMREST
LOCK
Quantum Q4