Troubleshooting Guide - Panasonic EASA-PHONE KX-T2470 Operating Instructions Manual

Troubleshooting Guide
Problem
Cause & Remedy
The unit does not work when I press I Plug in the AC adaptor then press the
any button. I pOWf n ON/OFF button to turn on
the unit.
The unit does not function. However, | .The cassette tape might be broken.
6 beeps sound and the display shows I
Replace it with a new one.
"Err".
| .Clean the heads. (See page 82.)
While recording an OGM, 6 beeps I Re-record your OGM. Speak clearly
and the announcement "Please
I and loudly, and do not pause for over
record your Outgoing Message again" | 2 seconds while recording.
are heard and the display shows
"Err".
When the cassette tape ls played
I Clean the heads. (See page 82.)
back, the sound level is low, even if
the VOLUME control is turned up
fully.
I have played back allthe recorded | .Wait for 7 seconds. The unit will be
messages and lwant to record the
I
ready to record the next phone call.
next phone call after the last I .ln case of remote operation, just
previously recorded messages.
I
hang up.
Some lCMs have not been recorded I Set the CpC mode to "B".
up to their end. I (See pages 13 and
't4.)
ICM transfer cannot be done.
I Telephone number has not been
stored into the transfer memory
station.
Make sure that the transfer mode is
set. (See pages 56 and 58.)
Problem
Cause & RemedY
The unit does not announce the time | .Set the time and day again.
and day when I press the TIME DAY |
(S"" pages 1 1 and 12.)
CHECK button.
I oAdjust the volume control.
My pager rings repeatedly. (When the I See NOTE on page 57.
pager's number is stored as the
transfer number.)
F
I
*
t
#
The unit has been set to the answer
| .tne cassette tape is cut or is not
mode, but no Incoming Messages are I
inserted. Insert the tape or replace it
recorded.
I with a new one.
oThe OGM is recorded improperly.
Record a new OGM.
oThe recording time mode is set to
"Announce only" (See page
1 7 and
1 8 . ) .
I press the button of a remote
I tv"t " sure that you are entering
telephone, but the unit does not
I yort correct remote code number'
respond.
I tRecord the OGM in a quiet place'
oln some areas, a remote touch tone
phone may not function due to
telephone line conditions such as
line noise, echo, etc.
oThe unit may not respond il a touch
tone telephone produces tones that
are too short to activate the unit.
When you press any button, Press
firmly.
- 6 5 -
- 6 6 -
-L
*