Blending In A Saucepan; Turbo Button - Morphy Richards Accents 48924 Instructions Manual

Hand blender set
Table of Contents

Advertisement

48924 rev1_Layout 1 18/04/2012 09:37 Page 4

Blending in a saucepan

Remove the saucepan from the heat.
1.
To avoid excessive splashing, place the Blending
2.
Leg
(5)
into the food before switching the Hand
Blender on.
Hold the pan steady with your other hand and
3.
press the On Button (3). Use a low speed setting
to start and increase the speed as needed.
Move the Blade
(6)
4.
up and down motion.
Allow the Blade to stop moving before removing
5.
from the pan.
WARNING: Lifting the Blade out of the food
while running, or using a high speed setting in a
small pan could splash hot liquid. Extra care
should be taken when using the Hand Blender
in this manner.
Do not insert the hand blender into the food
past the join between the Main Unit
Blending Leg (5).
Using the Balloon Whisk
Insert the Balloon Whisk
Gearbox (7). Attach the whisk onto the Main
Unit (2).
To avoid splashing, select a slow speed on the
Speed Control
(1)
Button
(3)
to start. Release the button to stop
BEFORE removing the Balloon Whisk from the
food.
4
through the food using a
(2)
and the
1 1
(8)
into the Whisk
3 3
and press and hold the On
Ensure the power cable does not touch any hot
surfaces (including the side of the pan.)

Turbo Button

The hand blender has 8 different speeds as well
as a Turbo Button (4). Press the Turbo Button to
run the hand blender on speed 8 for intermittent
bursts.
Note: The Chopping Bowl
only be used with the Speed Control
highest setting or when using the Turbo Button
(4). Using on a lower setting may cause
irreparable damage to the Hand Blender.
Usage
WARNING: Your hand blender set is designed
for intermittent use. Do not use continuously for
more than 1 minute. Allow to cool down for a
minimum of 5 minutes before further use.
Do not use continuously for more than 10
seconds when lifted out of food.
Place the Balloon Whisk into the ingredients.
Unplug from the mains before twisting the
Whisk Gearbox
(7)
to unlock from the Main
Unit (2). Pull the Balloon Whisk from the Whisk
Gearbox for cleaning.
(12)
attachment can
(1)
set to the
2
4 4

Advertisement

Table of Contents
loading

Table of Contents