Page 1
Sunbeam Pedestal Fan with Remote Control Instruction Booklet FA8900 40cm Pedestal Fan Please read these instructions carefully and retain for future reference.
Contents Sunbeams Safety Precautions Safety Precautions For Your Pedestal Fan Locating Your Pedestal Fan Features of Your Pedestal Fan Parts Identification Assembling Your Pedestal Fan Remote Control Using Your Pedestal Fan Care And Cleaning Important instructions – retain for future use.
• Never leave an appliance unattended while in use. If you have any concerns regarding the performance and use of your appliance, please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line. Ensure the above safety precautions are understood.
Safety Precautions For Your Pedestal Fan • Do not use outdoors. • Always unplug the fan when not in use. • Do not run the cord of the fan under • The fan must not be used if the guards are carpeting.
Locating Your Pedestal Fan 1.Always locate your fan on a level surface. 2.Your pedestal fan should be located in a dry, cool, well ventilated location. Keep your fan away from heat sources, corrosive gases and avoid direct sunlight. 3.Do not attempt to move your pedestal fan whilst it is operating.
Features Of Your Sunbeam Pedestal Fan Metal Grille Easily assembled, 50cm secure grille. Plastic Fan Blades 5 blades to effectively move the air about your room. Control Panel Simply press the on/off button to turn the unit on. Use the other buttons to select wind mode, timer, speed and oscillation functions.
2.Unfasten the interlocking nut and blade appears on the inside of the grill), the knob from the front of the motor Sunbeam logo should be straight. Push the (See Figure 2) and place to one side. round edges of the grill firmly together with the back grill and lock the clip.
Page 9
Assembling Your Pedestal Fan (continued) Connecting The Base Attaching the body and base 1.Locate the moulded securing knob. 1.Remove the screw from the upper fan shaft. Place to one side. 2.Insert the lower extension shaft firmly into the base and attach the moulded securing 2.Insert the upper fan shaft onto the lower knob to the underside of the base and extension shaft and insert the screw and...
Remote Control Remote control Oscillation Operates within 8 metres of the Your pedestal fan oscillates 70°, Pedestal Fan. distributing cool air throughout the room. Fan speed button Choose from 3 speed settings, Preset/Timer low medium or high. The preset timer allows you to set your pedestal fan to turn Wind Mode on/off after 1,2,4 or 8 hours.
Using Your Pedestal Fan Selecting a fan speed 1. Place the pedestal fan on a flat level surface 2. Adjust the height by turning the height 1. To select a fan speed simply press the adjustment knob, located on the lower ‘speed’...
Page 12
Using Your Pedestal Fan (continued) Oscillation Timer Press the oscillation button to choose from Pre-set to turn on three options of wind direction: To pre-set the timer to turn the fan on, place the fan in “standby” mode (on at the power horizontal direction outlet but off on the fan) press the preset/timer vertical direction...
Page 13
Using Your Pedestal Fan (continued) WIND MODES Sleep mode Press the mode button to select the desired Is identical to Soft mode with the advantage airflow type in sequence: that the set fan speed gradually decreases every 30 minutes. Stand mode The Fan will operate at the selected speed.
Care and Cleaning • Ensure that your pedestal fan is switched • Take care that excessive dust does not build off and disconnected from the power outlet up in or around the motor body. Use a dry before cleaning. soft brush or vacuum cleaner to remove it. •...
Page 15
You are also Alternatively, you can send a written claim entitled to have the goods repaired or to Sunbeam at the address listed below. replaced if the goods fail to be of acceptable On receipt of your claim, Sunbeam will...
Page 16
Sunbeam Corporation Limited 2012. ABN 45 000 006 771 Units 5 & 6, 13 Lord Street Botany NSW 2019 Australia Unit 3, Building D 26 Vestey Drive Mt Wellington Auckland New Zealand 6/12 Sunbeam Corporation is a division of GUD Holdings Ltd.