Logging Host Index - TP-Link TL-SG5428 Cli Reference Manual

Command Mode
Global Configuration Mode
Example
Clear the information in the log file:
TL-SG5428(config)# clear logging buffer

logging host index

Description
The logging host index command is used to configure the Log Host. To clear
the configuration of the specified Log Host, please use no logging host index
command. Log Host is to receive the system log from other devices. You can
remotely monitor the settings and operation status of other devices through the
log host.
Syntax
logging host index idx host-ip level
no logging host index idx
Parameter
idx —— The index of the log host. The switch supports 4 log hosts at most.
host-ip —— The IP for the log host.
level —— The severity level of the log information sent to each log host. There
are 8 severity levels marked with values 0-7. The smaller value has the higher
priority. Only the log with the same or smaller severity level value will be sent to
the corresponding log host. By default, it is 6 indicating that the log information
marked with 0~6 will be sent to the log host.
Command Mode
Global Configuration Mode
Example
Enable log host 2 and set its IP address as 192.168.0.148, the level 5:
TL-SG5428(config)# logging host index 2 192.168.0.148 5
90