Setting The Projector Id; The Remote Control - Epson PowerLite 4100 Installation Handbook

Epson PowerLite 4100 / 4200W / 4300
Use the pointer button to move the pointer on the screen.
Press the button once to left-click, or twice to double-click.
Enter
Press the button to right-click.
Esc
To drag-and-drop, hold down the
pointer button to drag the object. When it's where you want
it, release the button.
Enter
Operating Two or More Projectors With

the Remote Control

If you're using more than one projector, you can control all the
projectors—or just selected ones—by using the projector ID system.
To operate a projector, set the remote control's ID to match that of
the projector. Or you can control all the projectors at once by setting
the remote control's ID to zero.

Setting the Projector ID

The projector's default ID is set to O . This lets it respond to
commands from any remote control. To change the ID, follow these
steps:
1. Press the button on the remote control. You see the
Menu
projector's menu screen.
2. Select , press
Extended
again.
Enter
button. Then use the
Enter
, select
Enter Projector ID
, then press
INSTALLATION HANDBOOK
Remote Control Information
5