Black & Decker lSt136 Instruction Manual page 12

40v max lithium trimmer / edger
Hide thumbs Also See for lSt136:
Table of Contents

Advertisement

Available languages

Available languages

• Align the tabs on the spool
cap with the slots (R1) in the
housing (figure R).
• Push the cap onto the
housing until it snaps securely
into place.
CAutiON:
To avoid
tool damage, if the cutting
line protrudes beyond the
trimming blade, cut it off so
that it just reaches the blade.
REWiNDiNG SPOOl
(uSE ONlY .065 iN. ROuND DiAMEtER liNE) (FiGuRES S, t & u)
NOtE: Hand wound spools from bulk line are likely to
become tangled more frequently than Black & Decker factory
wound spools. For best results, factory wound spools are
recommended.
To rewind spool, follow the
steps below:
• Remove battery from tool.
• Remove the empty spool
from the tool as described in
REPlACiNG thE SPOOl".
• Make a fold at the end of
the cutting line at about 3/4
inch (19mm)(S1). Feed the
cutting line into one of the
line holding slots (S2) as
shown in figure S.
R
R1
S
S2
• Insert the 3/4 inch (19mm)
end of the bulk line into
the hole (t1) in the spool
adjacent to the slot as
shown in figure t. Make
sure the line is pulled tight
against the spool as shown
in figure t.
R2
• Wind the cutting line onto the spool in
the direction of the arrow on the spool.
Make sure to wind the line on neatly and
in layers. Do not crisscross (figure u).
• When the wound cutting line reaches
the recesses (t2), cut the line. (figure t).
• Fit the spool onto the tool as described
in "REPlACiNG thE SPOOl".
thE RBRC™ SEAl
S1
The RBRC™ (Rechargeable
Battery Recycling Corporation)
Seal on the Li-Ion battery (or
battery pack) indicates that the costs to recycle the battery
(or battery pack) at the end of its useful life have already been paid by
Black & Decker. RBRC™ in cooperation with Black & Decker and
other battery users, has established programs in the United States
to facilitate the collection of spent Li-Ion batteries. Help protect our
environment and conserve natural resources by returning the spent
Li-Ion battery to an authorized Black & Decker service center or to your
local retailer for recycling. You may also contact your local recycling center
for information on where to drop off the spent battery.
trademark of the Rechargeable Battery Recycling Corporation.
12
t2
t
t1
u
is a registered
RBRC™

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents