Setting The Flash - HP Photosmart R507 User Manual

2
Press Zoom In
until you reach the desired size in
the Image Display. A yellow frame
surrounds the area of the image
that will be captured. The
resolution number on the right side
of the screen also becomes smaller
as you digitally zoom. For example,
place of 4MP, indicating that the image is being reduced to
a size of 3.2 Megapixels.
3
When the yellow frame is at the desired size, press the
Shutter button to take the picture.
To turn digital zoom off and return to optical zoom, press
Out on the
Zoom Out
NOTE
Digital zoom reduces the resolution of an image, so
your picture will tend to be more pixilated than the same
image taken with optical zoom. If you just intend to e-mail
an image or post it to a website, this loss of resolution will
not be noticeable, but in situations where the highest
quality counts (such as printing), limit the use of digital
zoom. It is also recommended to use a tripod when using
digital zoom.

Setting the Flash

NOTE
The flash does not work in
Burst setting, or while recording video clips.
The Flash button lets you cycle through the flash settings on
the camera. To change the flash setting, press the
button until the desired setting appears in the Image Display.
The following table describes each of the flash settings on
the camera.
Chapter 2: Taking Pictures and Recording Video Clips
again and hold it
Zoom lever until digital zooming stops. Release
, and then press it again.
3.2MP appears in
Panorama mode, with the
Zoom
Flash
41