Specifications; Audio Power - Sony STR-DH750 Reference Manual

• This receiver supports security functions
that comply with the Bluetooth
specification to ensure secure connection
during communication using Bluetooth
technology. However, this security may
be insufficient depending on the setting
contents and other factors, so always be
careful when performing communication
using Bluetooth technology.
• Sony cannot be held liable in any way for
damages or other loss resulting from
information leaks during communication
using Bluetooth technology.
• Bluetooth communication is not
necessarily guaranteed with all Bluetooth
devices that have the same profile as this
receiver.
• Bluetooth devices connected with this
receiver must comply with the Bluetooth
specification prescribed by the Bluetooth
SIG, Inc., and must be certified to
comply. However, even when a device
complies with the Bluetooth
specification, there may be cases where
the characteristics or specifications of the
Bluetooth device make it impossible to
connect, or may result in different control
methods, display or operation.
• Noise may occur or the audio may cut off
depending on the Bluetooth device
connected with this receiver, the
communications environment, or
surrounding conditions.
If you have any questions or problems
concerning your receiver, please consult
your nearest Sony dealer.

Specifications

AUDIO POWER

SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(USA model only)
With 6 ohm loads, both channels driven,
from 20 – 20,000 Hz; rated 90 watts per
channel minimum RMS power, with no
more than 0.09% total harmonic distortion
from 250 milliwatts to rated output.
Amplifier section
Minimum RMS Output Power
(6 ohms, 20 Hz – 20 kHz, THD 0.09%)
90 W + 90 W
Stereo Mode Output Power
(6 ohms, 1 kHz, THD 1%)
105 W + 105 W
Surround Mode Output Power
(6 ohms, 1 kHz, THD 0.9%)
145 W per channel
1)
Measured under the following conditions:
Area
USA, Canada, Taiwan 120 V AC, 60 Hz
Australia
Brazil
2)
Reference power output for front, center,
surround, surround back and front high
speakers. Depending on the sound field settings
and the source, there may be no sound output.
Frequency response
Analog
10 Hz – 100 kHz, +0.5/–2 dB (with
sound field and equalizer bypassed)
1)
1)
1)2)
Power
requirements
230 V AC, 50 Hz
220 V AC, 60 Hz
7
GB