Advertisement
Verve
®
Instruction Booklet
This book covers the use and care of the following Verve
SR6585 Verve
58 Platinum Shot & Spray Iron with Safety Auto-Off
®
SR6575 Verve
57 Platinum Shot & Spray Iron with Safety Auto-Off
®
SR6565 Verve
56 Platinum Shot & Spray Iron with Safety Auto-Off
®
Please read these instructions carefully
and retain for future reference.
Irons
Irons:
™
Advertisement
Related Manuals for Sunbeam SR6585 Verve 58
Summary of Contents for Sunbeam SR6585 Verve 58
- Page 1 Verve Irons ® Instruction Booklet This book covers the use and care of the following Verve Irons: ™ SR6585 Verve 58 Platinum Shot & Spray Iron with Safety Auto-Off ® SR6575 Verve 57 Platinum Shot & Spray Iron with Safety Auto-Off ®...
-
Page 2: Table Of Contents
Contents Sunbeam’s Safety Precautions Features of your Verve Iron Using your Verve Iron The Safety Auto-Off Feature Care and Cleaning of your Verve Iron Ironing Tips & Tricks Ironing Chart Important instructions – retain for future use. -
Page 3: Sunbeam's Safety Precautions
• Never leave an appliance unattended while in use. If you have any concerns regarding the performance and use of your appliance, please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line. Ensure the above safety precautions are understood. -
Page 4: Features Of Your Verve Iron
Features of your Sunbeam Verve Iron Powerful shot of steam Pressing the shot of steam button instantly produces a powerful shot of steam to remove stubborn wrinkles. Vertical shot of steam Pressing the shot of steam button with the iron... - Page 5 Safety auto-off The iron automatically switches itself off if left in the ironing position (horizontal) for 30 seconds, or in the heel rest position (vertical) for 15 minutes. (For more information on the safety auto off feature see page 7). Power light Illuminates to indicate that the iron is connected to the power outlet and the power...
-
Page 6: Using Your Verve Iron
Verve iron without affecting the steam performance. However in 3. Turn the steam dial to the desired steam very hard water areas, Sunbeam recommends setting. the use of distilled water, or water which has been demineralised. -
Page 7: The Safety Auto-Off Feature
Using your Sunbeam Verve Iron (continued) Dry ironing NOTE: If the tank has run dry, it may be necessary to re-prime the pump after filling Follow steps 1 and 2 above. the iron with water. 3.Select DRY on the steam dial. -
Page 8: Care And Cleaning Of Your Verve Iron
Care and Cleaning After each use Cleaning the steam holes 1 Turn the power off and remove the plug To remove build up from the steam holes from the power outlet. which may affect steam performance, use a cotton wool tip moistened in 2 Allow the iron to cool before winding methylated spirits. -
Page 9: Ironing Tips & Tricks
Ironing Tips and Tricks Tip # 27 - Iron shirts like a pro Tip # 13 - Ironing the seam Start with the collar, working from the outer Always press seams in the same direction edges into the middle. Iron the shoulder they were made. -
Page 10: Ironing Chart
Ironing Chart Fabric Temp setting Ironing Ironing recommendation MINIMUM Acrylic Dry iron on reverse side of fabric Min to • MINIMUM Dry iron on reverse side of fabric Acetate while still damp Min to • MINIMUM Nylon Iron on reverse side of fabric Min to •... - Page 11 You are also Alternatively, you can send a written claim entitled to have the goods repaired or to Sunbeam at the address listed below. replaced if the goods fail to be of acceptable On receipt of your claim, Sunbeam will...
- Page 12 Sunbeam Corporation Limited 2010. ABN 45 000 006 771 Units 5 & 6, 13 Lord Street Botany NSW 2019 Australia Unit 3, Building D 26 Vestey Drive Mt Wellington Auckland New Zealand 6/11 Sunbeam Corporation is a division of GUD Holdings Ltd.