Advertisement
Installing or removing battery cartridge
Always switch off the tool before insertion
or
removal
of the
battery cartridge.
.To remove the battery cartridge, pull out
[
the set plate on the tool and grasp both
sides of the cartridge while withdrawing it
from the tool.
* T o insert the battery cartridge, align the
tongue on the battery cartridge with the
Battery cartridge
Set plate
v
groove in the housing and slip it into
place. Snap the set plate back into place.
Be sure t o close the set plate fully before
using the tool.
0
Do not use force when inserting the battery cartridge.
If the cartridge does not slide in easily, it is not being inserted correctly.
CAUTION :
If you pull out the
set
plate carelessly when extra staples and stored in the storage space
in the tool, the extra staples can fall out and present a danger to anyone or anything
below. Always hold the tool with the
set
plate facing up to prevent the extra staples
from falling out when you pull out the
set
plate.
Charging
Plug the fast charger into your power
source. Insert the battery cartridge so that
the plus and minus terminals on the bat-
tery cartridge are on the same sides as their
respective markings on the fast charger.
Insert the cartridge fully into the port so
that it rests on the charger port floor.
Press the start button (red). The charging
light will come on and charging will begin.
I f the charging light does not come on,
press the reset button (yellow) first, then
Charging light
Start button-
the start button (red). If the charging light goes out within 10 seconds even after pressing
the reset button and start button a couple of times, the battery cartridge i s dead. (CAU-
TION:
Wait for more than
5
seconds after the charging light goes out t o press the reset
button again.) Replace it with
a
new one. When the charging light goes out after about
one hour, you may remove the fully charged battery cartridge.
After charging, unplug the charger from the power source.
7
Advertisement
