Adjusting Air Pressure; Loading Staples; Stapler Operation - Hitachi N 3804AB3 Instruction And Safety Manual

English
(7) If no abnormal operation is observed, you may
load staples in the Stapler.
Drive staples into the workpiece that is the same
type to be used in the actual application.
THE STAPLER MUST OPERATE PROPERLY.

ADJUSTING AIR PRESSURE

WARNING
Do not exceed 120 psi (8.3 bar 8.5 kgf/
2
cm ).
Adjust the air pressure at recommended operating
pressure 70 – 120 psi (4.9 – 8.3 bar
2
5 – 8.5 kgf/cm ) according to the length of staples and
the hardness of workpiece.
The correct air pressure is the lowest pressure which
will do the job. Using the Stapler at a higher than
required air pressure unnecessarily over stresses the
Stapler.

LOADING STAPLES

WARNING
When loading staples into Stapler,
1) do not pull trigger;
2) do not depress push lever; and
3) keep Stapler pointed downward.
(1) Pull the staple feeder backward, and confirm that
the feeder stopper is securely lodged in the feeder
stopper hole on the staple feeder.
Staple feeder
(2) Place the staple strip over the magazine.
Make sure that the staple strip slides freely on the
magazine.
12
Feeder stopper
Staple
(3) Pull the staple feeder backward slightly, and press
in the feeder stopper. Push the staple feeder
forward. Gently set the staple feeder to the back
of the loaded staples.
The Stapler is now ready to operate.
CAUTION:
If the staple feeder is released all of a sudden, it
can return abruptly, causing deformation and/or
scatter, eventually ending up in clogged staples.
Be absolutely sure to bring back the staple feeder,
avoiding any impact.

STAPLER OPERATION

Read section titled "SAFETY"(pages 4 – 6).
DANGER
WARNING
Magazine
Feeder stopper
1
2
3
Staple feeder
Operators and others in
work area MUST wear
safety glasses with side
shields which conforms to
ANSI Z87.1 specifications.
NEVER point tool at
yourself or others in
work area.
Keep fingers AWAY from
trigger when not driving
staples to avoid
accidental firing.