HP vf51 User Manual page 25

Note:
Auto Configuration uses state-of-the-art signal processing algorithms based on the image
displayed on your screen. Therefore, you should not change the image on your screen
while Auto Configuration is running.
Once you have executed Auto Configuration for a particular mode, the monitor will store the new
values in its permanent memory.
To execute Auto Configuration using the Direct Key function:
1. Make sure the OSD Main Menu is not displayed onscreen. Press the Down (
the AUTO CONFIG submenu and start running Auto Configuration.
2. After Auto Configuration has finished, you should have a stable and clear image.
Adjusting Brightness Using the Direct Key
To adjust brightness directly:
1. Make sure the OSD Main Menu is not displayed onscreen. Press the Up (
BRIGHTNESS submenu.
▲
2. Press the Up ( ) or Down (
3. Press the Select button to close and exit the BRIGHTNESS menu.
▼
) buttons to increase or decrease the brightness setting.
21
▼
) button to open
▲
) button to open the
MAIN PAGE