Identifying Monitor Conditions - HP LP2065 20" User Manual

Operating the Monitor
■
Multiple preset display settings for a single user based on
content and ambient lighting.
■
Asset Management and Power Management capabilities that
include remote control for individual or a group of displays
on the domain from a centralized console application.
The HP Display Assistant Utility has two modes of operation:
Wizard and OSD mode. The preferred method of use is Wizard
mode, which takes you through a step-by-step process to
accurately calibrate the monitor. This method relies on a
sequence of steps that will obtain the best display results when
completed.
✎
Refer to HP Display Assistant documentation for additional
information on monitor control limitations based on the version
of your computer's operating system.

Identifying Monitor Conditions

Special messages will appear on the monitor screen when
identifying the following monitor conditions:
■
Input Signal Out of Range— Change resolution setting to
1600 x 1200 - 60Hz (HP LP2065 20" Model) or 1920 x 1200
- 60 Hz (HP LP2465 24" Model) — Indicates the monitor
does not support the input signal because the resolution
and/or refresh rate are set higher than the monitor supports.
■
No Input Signal— Indicates the monitor is not receiving a
video signal from the PC on the monitor video input
connector. Check to determine if the PC or input signal
source is off or in the power saving mode.
4–16 User Guide