Troubleshooting Guide; Metal Detecting Code Of Ethics - Garrett AT Gold Owner's Manual

TrOuBleSHOOTING GuIDe

SYMPTOM
1. Ensure batteries are installed in the correct position.
No power
2. Replace all old batteries with all new batteries.
1. Ensure your searchcoil is securely connected and the coil
cable is snugly wound around the stem.
2. If using the detector indoors, be aware that excessive
amounts of electrical interference exists, plus excessive
Erratic sounds or
amounts of metal can be found in floors and walls.
target ID cursor
3. Determine if you are close to other metal detectors or other
movement
metal structures such as electrical power lines, wire fences,
benches, etc.
4. Adjust frequency.
5. Reduce your sensitivity setting.
Intermittent signals typically mean you've found a deeply
buried target or one that is positioned at a difficult angle for
your detector to read. Scan from different directions to help
Intermittent Signals
define the signal. (NOTE: Iron targets may cause Intermittent
Signals. You can help identify iron targets with the Iron Audio
feature).
Ensure you are using the correct mode for the type hunting
you are doing. If specifically hunting for U.S. coins, DISC 2
I'm not finding
mode should be your best choice to eliminate other undesirable
specific targets
targets. The ALL METAL or DISC 1 modes will detect all
metal targets to ensure desired targets are detected.
If your Target ID Cursor bounces erratically, chances are
you've found an iron target. However, a Target ID Cursor may
bounce if a good target (such as a coin) is not parallel to the
searchcoil (e.g. on edge). It may also bounce if there is one
or multiple "junk" targets laying next to the good target. Scan
Target ID Cursor
from different directions until your Target ID Cursor becomes
bounces
more stable.
NOTE: Large, flat pieces of iron—depending on their
orientation in the ground—can read as a good target or can
cause erratic Target ID Cursor movement. Use Iron Audio
feature to help identify iron targets.
58 Garrett Metal Detectors
SOLUTION

MeTAl DeTeCTING CODe OF eTHICS

The following is a Code of ethics that many treasure hunt
clubs endorse and hobbyists follow to preserve our exciting
hobby of metal detecting. We encourage you to do the same:
• I will respect private and public property, all historical and
archaeological sites and will do no metal detecting on
these lands without proper permission.
• I will keep informed on and obey all local and national
legislation relating to the discovery and reporting of found
treasures.
• I will aid law enforcement officials whenever possible.
• I will cause no willful damage to property of any kind,
including fences, signs and buildings.
• I will always fill the holes I dig.
• I will not destroy property, buildings or the remains of
deserted structures.
• I will not leave litter or other discarded junk items lying
around.
• I will carry all rubbish and dug targets with me when I leave
each search area.
• I will observe the Golden Rule, using good outdoor manners
and conducting myself at all times in a manner which will
add to the stature and public image of all people engaged
in the field of metal detection.
59
AT Gold ™