Table of Contents
Advertisement
The HDMI
devices. If your HDMI
features, the TV may not work properly when this feature is enabled.
HDMI
Information Display
TM
Viewing the HDMI
1
From the Options menu, highlight HDMI Information
Display, and then press the ENTER button.
2
Press the /▼(arrow) buttons to select On or Off, and then
press the ENTER button.
3
Press the INFO button. The normal banner and signal
information banner appear.
Displaying TV status information
To display TV status information using the RECALL button:
Press the RECALL button on the remote control.
v
The following information will be displayed (if applicable):
Current input (ANT/CABLE, Video, etc.)
v
If ANT/CABLE is the current input, either "CABLE" (for cable
v
TV) or "ANT" (for over-the-air broadcasts).
Channel number (if in ANT/CABLE mode)
v
Digital signal strength indicator (bar graph in lower right
v
corner of box; for digital signals only)
Stereo, Mono, or SAP audio status (when in HDMI
v
mode, Dolby
Video resolution
v
Aspect ratio of incoming video signal (4:3 or 16:9)
v
V-Chip rating status
v
GameTimer (if set)
v
setting (RGB Range) needs proper HDMI
TM
TM
signal information:
TM
The signal information banner will appear when this feature is set to
On and you watch an HDMI
If you press the INFO button when this feature is set to Off, only the
normal banner will appear.
Digital, or PCM)
®
Displaying TV status information
source device does not support these
input.
TM
Setting up your TV
source
TM
input
TM
89
Hide quick links:
Advertisement
Table of Contents
