Removing And Installing The Glass Enclosure Panel - Lennox Hearth Products Merit MLBV-35NM Care And Operation Instructions Manual

LENNOX HEARTH PRODUCTS • MERIT
REMOVING AND INSTALLING
THE GLASS ENCLOSURE PANEL
WARNING
• Do not attempt to substitute the
materials used on this door or
replace cracked or broken glass.
• Handle this glass with extreme
care! Glass is susceptible to
damage; do NOT scratch or
handle roughly while reinstalling
the glass door frame.
• The glass door(s) of this appli-
ance must only be replaced as
a complete unit as provided by
the manufacturer. Do not attempt
to replace broken, cracked, or
chipped glass separately.
• Do not attempt to touch the front
enclosure glass with your hands
while the fireplace is in use.
WARNING
Do not operate appliance with
the glass front removed, cracked
or broken.
AVERTISSEMENT
Ne pas utiliser l'appareil si le pan-
neau frontal en verre n'est pas en
place, est craqué ou brisé.
WARNING
Any safety screen or guard
removed for servicing the appli-
ance must be replaced prior to
operating the appliance.
AVERTISSEMENT
Tout écran ou protecteur retiré
pour permettre l'entretien de
l'appareil doit être remis en
place avant de mettre l'appareil
en marche.
SERIES B-VENT GAS FIREPLACES • MODELS MLBV-35, MLBV-40 • CARE AND OPERATION INSTRUCTIONS
®
Only doors certified with the appliance
shall be used.
Seules des portes certifiées pour cet
appareil doivent être utilisées.
CAUTION: DO NOT abuse glass enclosure
panel by striking or slamming shut.
This appliance is designed to operate only
when the glass enclosure panel is installed.
Do NOT remove the glass enclosure panel un-
less necessary (e.g., to gain access to compo-
nents within the firebox or to clean the glass).
Removing the Glass Enclosure Panel
1. Refer to Figure 6. To access the spring
latches securing the front glass enclosure
panel, open the lower control compartment
door by lifting and pulling the bottom panel
forward.
2. Pull the spring latches forward and down to
release them from the lower door channel.
3. Pull the bottom of the glass enclosure panel
out a few inches, and grasp it on the right
and left sides. Gently lift to release the panel
from its upper channel, and then pull the
enclosure panel forward to remove it.
4. Visually inspect the gasket on the backside
of the enclosure panel frame. The gasket
surface must be clean, free of irregularities,
and firmly seated.
Installing the Glass Enclosure Panel
1. Refer to Figure 6. Position the glass enclo-
sure panel in front of the firebox opening,
with the bottom of the enclosure panel held
away from the fireplace. Hook the top flange
of the enclosure panel frame over the top of
the firebox frame.
2. Gently move the bottom of the enclosure
panel frame toward the fireplace, ensuring
that the gasket seats evenly. Fasten the
two latches under the firebox floor to the
vee-flange on the enclosure panel. Close
both latches securely.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Glass
Door
Glass
Door
Glass Door
Spring Latch
Glass Door
Spring Latch
Control
Compartment
Panel
Control
Compartment
Figure 6
Panel
Header
Spacing
Header
Spacing
Top
Top
Standoffs
Standoffs
5/8"
5/8"
Nailing
Nailing
Flange
Flange
1/2"
1/2"
Nailing
Nailing
Flange
Flange
Flush
Nailing
Flange
Flush
Nailing
Flange
Hood
Hood
11