Nikon FG Instruction Manual page 26

Too much light Too little light
Shutter speed
is too slow
i,'loo
,00
125
bO
30
IS
8
• Either upper or lower warning LED blinks .
A blinking upper LED means too much light; try
either a nGutral density filter or change to a slower
speed film A blinking lower LED means too little
light, use an electronic flash or switch from P to a
long exposure at B setting
• The LED lights up at 1/30 sec or below
Shutter speed is too slow for hand-held shooting
and picture blur may result Use a tripod to steady
the camera, change to high speed film, or use an
electronic flash
26
f/stop is not set at fl11
or a larger flnumber.
1
'000
:Joo
150
11\
00
30
15
Notes:
During blank exposure both 1/60
and 1/125 sec. LEOs light up.
1)
If
the flstop is not set at fill or
a
larger flnumber, both
warning LEOs blink alternately. Reset the flstop to its mini-
mum aperture setting (the largest flnumber) , When using
a
Nikon Teleconverter TC200, TC300, or TC 14, PK ring or
AI-converted lens, be sure to set the aperture to its mini-
mum opening since the warning LEOs will not blink in
warnmg
2) If you do not wish to turn on the audio warning system,
check the LEOs in the viewfinder before shooting to con-
firm if any adjustments are necessary in order to assure
correct exposure.
3) During blank exposures before the frame counter reaches
"1," both the 1/60 and 1/125 sec. LEOs will light up as the
shutter is automatically set at 1/90 sec
00
not take
pictures before "1" as the exposure meter does not
opera te until"
1 "