Advertisement
CR-320 Big-Display AM/FM Clock Radio w/Dual Alarms
(120-1621B)
Connecting to AC Power
Plug the clock radio's power cord into a standard AC outlet.
flashes and the BATTERY SENTINEL indicator light next to the time display
turns on (see "Installing a Back-Up Battery" below).
Installing a Back-Up Battery
Your clock radio uses a 9V battery (not supplied) to operate the clock and
alarm during a power failure.
the time for at least 8 hours, and the alarm will sound (if set) for at
least 10 minutes after power fails.
recommend a RadioShack alkaline battery.
CAUTION:
Use only a fresh battery of the required size and recommended
type.
Note:
To prevent unnecessary drain on the battery, install it only after
connecting the clock radio to AC power.
1.
Press the tab and lift off the battery compartment cover on the bottom
of the clock radio.
2.
Snap the clock radio's battery contacts onto the battery's terminals,
then insert the battery into the compartment.
indicator turns off.
Note:
If the BATTERY SENTINEL indicator remains lit, press SNOOZE to
reset the indicator.
up battery.
3.
Replace the cover.
The BATTERY SENTINEL indicator lights if the back-up battery is not
installed or needs to be replaced.
WARNING:
Always dispose of old batteries promptly and properly.
bury or burn them.
Preparation
The display turns off, but the clock keeps
For the best performance, we
If that does not work, replace the back
Faxback Doc. # 56277
The display
The BATTERY SENTINEL
Do not
Advertisement
