Advertisement
3
INSTALLATION
• Actual terminal location;
Do not peel off
tape when IER-2
is not used.
WHITE wire
(x 2) for IER-2
4
MOUNTING
Mounting
bracket
Screw (x 2)
Attach mounting bracket to single-gang box or wall.
Aligning at the marks, insert all the prongs of bracket into the unit.
Pull the unit downward until properly locked.
Be careful not to attach the bracket upside down.
5
WIRING
AC transformer
Door station
IF-DA
NP
1
2
Door
release
EL-12S
NP:Non-polarized
Aiphone warrants its products to be free from defects of material and workmanship under normal use and service for a period of
one year after delivery to the ultimate user and will repair free of charge or replace at no charge, should it become defective upon
which examination shall disclose to be defective and under warranty. Aiphone reserves unto itself the sole right to make the final
decision whether there is a defect in materials and/or workmanship; and whether or not the product is within the warranty.
This warranty shall not apply to any Aiphone product which has been subject to misuse, neglect, accident, power surge or to use
in violation of instructions furnished, nor extended to units which have been repaired or altered outside of the factory. This
warranty does not cover batteries or damage caused by batteries used in connection with the product.
This warranty covers bench repairs only, and any repairs must be made at the shop or place designated in writing by Aiphone.
Aiphone will not be responsible for any costs incurred involving on site service calls. Aiphone will not provide compensation for
any loss or damage incurred by the breakdown or malfunction of its products during use, or for any consequent inconvenience or
losses that may result.
AIPHONE CO., LTD., NAGOYA, JAPAN
AIPHONE CORPORATION, BELLEVUE, WA, USA
AIPHONE S.A.S., LISSES-EVRY, FRANCE
Back view
IE-1AD(U)
+
–
1
2
L
L
Single-gang box
83.5mm
(3-5/16")
Connecting
Mark
cables
Room master station
IE-1AD(U)
AC
+
_
Call extension
IER-2
1
2
L
L
WHITE
WHITE
NP
6
OPERATIONS
Communication;
Momentarily depress CALL button on door station.
Incoming call is announced by 4-stroke chime at room master
station and call extension if installed.
To reply, simply pick up handset at room master station. After
communication, hang up handset onto its cradle properly.
To operate door release;
While holding handset, depress and hold down DOOR RELEASE
button on room master station. The visitor may open the door while
buzzing sound is heard.
To adjust chime volume;
Adjust volume at room master station as desired by the slide switch on
room master station, according to the room conditions.
7
SPECIFICATIONS
• Power source: AC12-16V. DC12-24V.
• Current consumption: Max. 180mA (AC12-16V). Max. 160mA (DC12-24V).
• Calling: 4-stroke electronic chime (with adjustable volume)
• Communication: Simultaneous with handset
• Wiring: 2 wires to door, non-polarized.
Run audio wires in a separate-jacketed cable from door release's.
• Wiring distance: Between IE-1AD(U) and door station
Diameter
0.5mm
Distance
90m
AWG
24AWG
Distance
300'
Between IE-1AD(U) and power supply: 10m with 0.65mm. 33' with 22AWG.
• Door release button contact rating: AC/DC24V, 0.5A
• AC transformer requirements: AC12-16V, 450mA or more (with EL-12S)
AC12-16V, 700mA or more (with other manufacture's)
• Door release requirements: EL-12S, AC12V. Other manufacture's rated
AC12-16V not more than 500mA when powered by an AC
transformer of system.
• Dimensions & weight: 210H x 80W x 58D (mm).
WARRANTY
- 2 -
(IE-1AD(U))
0.65mm
0.8mm
1.0mm
150m
230m
360m
22AWG
20AWG
18AWG
500'
750'
1,180'
8-1/4"H x 3-1/8"W x 2-5/16"D.
Approx. 450g (1 lb.)
http://www.aiphone.net/
Printed in Vietnam(E)
FK1787 1211
B
OQ
Advertisement
