Printronix P7000 User Manual page 121

PTX Transparent
Lead-in Chars
You can enable additional features that are not available in standard Twinax
emulations. To access these features, send text commands in the data
stream. The commands must have a start and end code. Three sets (each
containing a start and end code) are available:
•
Set 1. start code: <%
stop code: >
¬¬
•
Set 2. start code:
stop code: $
•
Set 3. start code: _%
stop code: _
•
User Defined
Usr Defined HTRN
This option is used in Twinax SPC emulation. The range is ASCII character.
This option allows users to define ther own lead-in characters for the
Printronix Specific commands. Select a hex value for the following codes for
the User Defined option:
•
Start Code 1 5F
•
Start Code 2 5F
•
Stop Code 5B
Alt. Set 80-9F
•
Printable (default). Prints data in the range of hex 80 through hex 9F.
•
Control Code. Interprets data in the range of hex 80 through hex 9F as a
control code.
Graphic Chek Err
Allows overriding of the host setting for the SGEA (Set Graphic Error Action)
command. For more information about the SGEA command, refer to the
Coax/Twinax Programmer's Reference Manual.
•
Enable (default). The host setting for the SGEA used by the printer. If the
SGEA command is requested to stop on graphic errors, the printer will
stop when a graphic error is detected.
•
Disable. Ignores the SGEA command from the host. The printer does not
stop when an error is detected; instead, it substitutes the character
selected in the Graphic Chek Code parameter.
Twinax Params
121