Video; Video Receiver; Onnecting; Hooking Up The Video Sender - X10 RVK35 Owner's Manual

V R
IDEO ECEIVER
TV Output
Connector
TV Channel
A/V Input
Switch
Jacks
(on bottom)
2.4 GHz

Video

Antenna
ON-OFF
Switch
(on side)
Power Supply
Jack
2.4 GHz Channel
Switch
(on bottom)
8
C

ONNECTING

H V S
OOKING UP THE IDEO ENDER
1. Connect one set of Audio/Video cables to the VIDEO and AUDIO jacks
of your Video Sender. Take care to match the colors of the plugs on the
cable with the jacks on the Video Sender.
2. Connect the other end of the cable to the Audio/Video OUT jacks on
your primary TV (the one you want to send the picture FROM). Take care
to match the colors of the plugs on the cable with the jacks on the TV. If
the jacks on the TV are colored differently, connect the yellow plug to
the jack labelled VIDEO, the red plug to the jack labelled AUDIO RIGHT
and the white plug to the jack labeled AUDIO LEFT.
Note: If your TV does not include Audio/Video OUT jacks, you will
need to remake the connections as shown in diagram b) using the TV
antenna (coaxial) connections to link up the DSS Receiver/Cable Box/VCR
to your TV.
A/V Cable
a) Connections for a TV
with A/V OUT jacks.
U
P
Coaxial
Cable
b) Connections for a TV
without A/V OUT
jacks.
9