Kodak i1400 Series User Manual page 143

138
so you can access the separation roller.
NOTE: Use caution as the separation module is spring-loaded and
will snap back if you do not hold it in place.
6. Hold onto the separator module in this position with one hand, and
with the other hand remove the separator roller.
7. Gently lower the separator module release lever back into place and
set the separator module aside.
8. Remove each tire by sliding it off the core.
9. Install each new tire by gently stretching it over the core.
IMPORTANT: Do not overstretch the tire; it may tear.
Make sure that the tire is centered on the core and lies
flat.
10. Reinstall the core (the direction does not matter).
11. Reinstall the separator module.
12. Lower the scanner cover and press it down firmly until it latches into
place.
A-61550 May 2007