Configuring The Lan Over Usb Interface Manually - IBM BladeCenter HS22 Type 7870 Installation And User Manual

b. In the navigation pane, click System Settings and scroll down to the
Miscellaneous area.
c. Select the Do not allow commands on USB interface check box to
disable the USB in-band interface. Selecting this option does not affect the
USB remote presence functions (for example, keyboard, mouse, and mass
storage). When you disable the USB in-band interface, the in-band
systems-management applications such as the Advanced Settings Utility
(ASU) and firmware update package utilities might not work.
Note: The ASU works with a disabled USB in-band interface if an IPMI
device driver is installed.
If you try to use systems-management applications while the in-band
interface is disabled, they might not work.
d. Click Save.
v Use the following steps to disable the LAN over USB interface from the
Advanced Management Module (AMM) Web interface:
a. Log in to the AMM Web interface.
b. In the navigation pane, click Blade Configuration under the Blade Tasks
heading.
c. Scroll down to the Service Processor LAN over USB interface are on the
Blade Configuration web page. The section lists all blades in the chassis
which are capable of enabling and disabling the LAN over USB interface.
d. Select the check boxes next to the blade or blades that you want to enable
or disable.
e. Click the Disable button to disable the LAN over USB interface on the
selected blades.

Configuring the LAN over USB interface manually

The IMM using the LAN over USB interface requires operating-system drivers and
other configuration. The firmware update package or Advanced Settings Utility
attempt to perform the setup automatically, if needed. If the automatic setup fails
or if you prefer to set up the LAN over USB manually, use one of the following
processes. For more information about LAN over USB configuration on different
operating systems, see the IBM white paper Transitioning to UEFI and IMM on the
IBM web site (see "Related documentation" on page 2 for information on how to
find publications for your blade server).
Windows IPMI device driver
The Microsoft IPMI device driver is not installed by default on Microsoft Windows
Server 2003 R2 operating systems. To install the Microsoft IPMI device driver,
complete the following steps:
1. From the Windows desktop, click Start → Control Panel→ Add or Remove
Programs.
2. Click Add/Remove Windows Components.
3. From the component list, select Management and Monitoring Tools, and then
click Details.
4. Select Hardware Management.
5. Click Next. The installation wizard opens and guides you through the
installation.
Note: The Windows installation disk might be required.
Chapter 4. Configuring the blade server
55