SRP-X500P System Integration Guide
3. Place the remote commander so that its top points
towards the remote emitter/sensor, and then ready the
remote commander for programming commands from
the SRP-X500P.
10 cm or less
4. Press the IR OUTPUT MODE button. The button and the
remote emitter/sensor flash, and commands are output
from the remote emitter/sensor.
5. When programming has completed, press the IR
OUTPUT MODE button again. The button lights up and
the command output stops.
28
Programmable remote
commander
6. To program other functions, repeat this procedure from
step 2.
7. Hold down the IR OUTPUT MODE button for two
seconds or more. The button and the remote emitter/
sensor turn off and the SRP-X500P returns to normal
status. After programming has completed, be sure to
verify that the command has been correctly
programmed. If it has not, repeat the procedure from
step 1.