Advertisement
Built-In All-Refrigerator Specifications
•
Product Weight – 240 Lbs.
An electrical supply with grounded three-prong receptacle is required.
•
The power supply circuit must be installed in accordance with current
edition of National Electrical Code (NFPA 70) and local codes &
ordinances.
•
Voltage Rating – 120V / 60 Hz / 20 Amps
Connected Load (kW Rating) @ 115 Volts = 0.55 kW
•
•
Amps @ 115 Volts = 5 Amps
•
Always consult local and national electric codes.
•
Minimum 25-1/4" depth requires recessed electrical outlet.
•
To allow for ease of installation, tape excess power cord to back of unit.
•
When installing refrigerator adjacent to wall, cabinet or other appliance
that extends beyond front edge of unit, 20" minimum clearance
recommended to allow for optimum 140° door swing, providing
complete drawer / crisper access and removal. (Absolute 4" minimum
clearance will ONLY allow for 90° door swing which will provide limited
drawer / crisper access with restricted removal.)
•
Refrigerator must be placed on level surface of hard material, same
height as flooring. Surface must support approximately 800 lbs. when
fully loaded. Unit equipped with 4-point leveling.
USA
10200 David Taylor Drive
Charlotte, NC 28262
•
•
CANADA
5855 Terry Fox Way
Mississauga, ON L5V 3E4
•
•
FPRH19D7L 09/11
1-800-FRIGIDAIRE
frigidaire.com
•
•
1-800-265-8352
frigidaire.ca
•
•
© 2011 Electrolux Home Products, Inc.
"Built-In Look" Specifications
•
Minimum opening of 72" H x 33" W x 25-1/4" D required for single-
unit "Built-In Look" installation; 66" W required for double-unit
installation. (72" H to be measured from finished floor to underside
of soffit or overhead cabinet.)
•
Remove all wall / floor molding prior to built-in installation.
Optional Trim Kit Specifications
•
If optional Single or Double Louvered Trim Kit is to be used, different
cutout dimensions are required. Kit can be adapted to fit either 75"
or 79" opening height. (Refer to cutout dimensions on this page and
detailed Louvered Trim Kit installation instructions included with kit
or on web.)
•
Remove all wall / floor molding prior to built-in installation.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at frigidaire.com for detailed instructions.
Optional Accessories
•
Single Louvered Trim Kit – (PN # TRIMKITEZ1).
•
Double Louvered Trim Kit – (PN # TRIMKITEZ2).
•
PureAdvantage® Air Filter
Replacement Cartridge – (PN # 241754001).
All Refrigerator
FPRH19D7L F
19 Cu. Ft.
Specifications
subject to change.
Printed in the U.S.A.
Advertisement
