After Installation - Scotsman DCE33 User Manual

DCE33

AFTER INSTALLATION

Reversing Door Swing:
The hinged side of the door may be reversed to
the other side if desired:
The DCE33 was shipped with the door hinged at
the right. The door and hinges are designed for
placing the hinges on either the right or the left
side of the cabinet. Moving the hinges to the left
allows the door to pivot from the left side.
Note: There is a part, packed with the machine,
Door Handle
that is required for this procedure.
1. Open the door and remove the three screws
holding the lower hinge to the cabinet.
Hinge
2. With the door open enough to see both
Filler Plate
screws at the top door hinge, remove the two
screws. The door is now free of the cabinet.
3. Remove the single screw and the hinge
filler plate from the top of the door.
4. Install the other filler plate (shipped inside
refrigerator compartment) onto the top corner
of the door where the hinge was.
5. Remove the three plastic plugs from the
top front corner where the hinge will mount.
6. Remove the three plastic plugs from the
lower front corner where that hinge will
mount.
7. Remove the three screws holding the top
hinge to the cabinet. Remove that hinge from
the top and, flipping it upside down, install it
onto the bottom of the door, on the opposite
side using the original screws.
8. Remove the hinge assembly from the
bottom of the door, and flip it upside down;
secure it to the cabinet at the opposite side
top position with the original screws.
9. Hold the door up to the cabinet. Secure
the door to the top hinge with the original
screws.
Hinge
10. Secure the bottom hinge to the cabinet
with the original screws.
11. Place the plastic plugs removed earlier Magnetic
Door
Gasket
into the empty holes.
12. Check operation of the door by opening
Reverse Hinges From Top to Bottom and
and closing it.
Left to Right to Reverse Door Swing
September 2011
Page 12