ProCurve 420 Installation And Getting Started Manual page 43

Here is some information on the basic IP address and wireless configuration
parameters. For more information on these parameters, see the Management
and Configuration Guide, available on the ProCurve Web site at
http://www.hp.com/rnd/support/manuals/420.htm:
Parameter Default
Username admin
Password none
IP Address 192.168.1.1
Subnet Mask 255.255.255.0
Default Gateway 192.168.1.254
Primary SSID Enterprise
Wireless AP 1
Channel 0 (AUTO)
Wireless Operation Disabled
Note: The IP address and subnet mask assigned for the access point must be compatible with the IP addressing used
in your network. For more information on IP addressing, see the Management and Configuration Guide, available on
the ProCurve Web site at http://www.hp.com/rnd/support/manuals/420.htm.
Getting Started With Access Point Configuration
The name of the manager.
The password for the manager.
IP address compatible with your network.
Subnet mask compatible with your network.
IP address of the next-hop gateway node for network traffic that needs to be
able to reach off-subnet destinations.
The primary Service Set Identifier (SSID) interface for the access point. Only
the primary SSID is broadcast in the access point's beacon frames.
The radio channel through which the access point communicates with its
wireless clients. When attempting to connect, most wireless clients
automatically set their radio channel to the same channel used by the access
point.
Wireless operation can only be enabled after you have set the country code.
3-7