Water Tank; Ultrasonic Disk - Germ Guardian H4600 Use And Care Instructions Manual

6. 7.
Power Button Cool or Warm
Humidification Button
Before turning on make sure
there is water in the unit. Press Press to select cool or warm mist.
the POWER button. Water temperature is maintained
at room temperature for cool
setting and 80 degrees for warm.
9.
10.
Night Light Feature
Water Refill Button
Press the Night Lamp button at
When the Water Refill button lights
the top of the unit to illuminate
up it is time to refill the water tank.
the night light feature.
E-6
8.
Spray Control Button
When you press the Spray Control
button there are three options:
Press once for LOW
Press twice for MEDIUM
Press three times for HIGH
*Lights get higher as spray increases.
11.
Humidity Spout Direction
Broaden mist in two different
directions throughout the room.
• Always unplug the unit before servicing it in any way.
• The water temperature of the water remaining in the unit after use may be high.
• Do not submerse the unit in the water, or allow water to enter the inside of the unit.
INSIDE THE BODY OF THE UNIT
Pour excess water out of the unit, but do not allow it to enter the blast port. Wash
out the unit with fresh water using the cleaning brush and a soft cloth as needed.
OUTER SURFACE OF THE UNIT
Wipe the surface of the unit with a soft, damp cloth if needed.

WATER TANK

If water spots remain in the water tank, wipe the inside down with a soft cloth.
Do NOT use soap or detergents.

ULTRASONIC DISK

Remove the tank (Fig. 1) and use the enclosed cleaning brush to regularly remove
build up and deposits from the disk area (Fig. 2).
**Diluted white vinegar will help to prevent this build up.
(Fig. 1) (Fig. 2)
• Clean and fully dry the inside and outside of the unit before storing it.
• DO NOT leave water in the unit.
• Store in a cool, dry place.
*Clean the disk with the
brush only. No other
cleaning tool should
be used. BRUSH ONLY.
(Fig. 2)
Ultrasonic Disk
E-7