Setting The Volume Limit (Max Vol Level); Setting The Network (Network Info.) - Denon Cocoon Quick Setup Manual

Setting the volume limit
(Max Vol Level)
Make a setting for maximum volume.
• The factory default setting is "50".
1
Press + and – at the same time.
Turns on the menu settings mode and the menu appears on the
display (vpage 20 "Menu map").
Menu
Language
2
Press + or – to select "Max Vol Level", then press
13.
"Max Volume" menu appears.
3
Press + or – to select the volume "0 – 50", then press
13.
The top menu is displayed again.

Setting the network (Network Info.)

Checking the network information
1
Press + and – at the same time.
Turns on the menu settings mode and the menu appears on the
display (vpage 20 "Menu map").
Menu
Language
2
Press + or – to select "Network Info.", then press
13.
3
Press + or – to select the item you want to check.
13
• Select "Exit" and press to return to the top menu.
23
WPS Settings (PIN code method)
Use this procedure to configure the wireless LAN settings.
Before turning this unit on, make sure that an Ethernet cable is not
connected to this unit. If a cable is connected, have this unit enter the
power standby mode and disconnect the cable.
1
Press + and – at the same time.
Turns on the menu settings mode and the menu appears on the
display (vpage 20 "Menu map").
2
Press + or – to select "WPS(PIN)", then press 13.
"Searching" is displayed, and the access point you have set is
displayed.
3
Press + or – to select the access point whose PIN code
you want to display, and press 13.
PIN code number is displayed.
4
Set this PIN code to the register.
When connection is established with access point, "Succeeded"
is displayed.
• For how to register the PIN code, see the owner's manual of your
router with access point.