Onkyo DV-CP706 Setup Manual

DV-CP706 HDMI Setup Guide
HDMI carries audio and video via a single cable. An HDMI connection can:
• Carry high-definition video digitally (1080p/1080i/720p up conversion)
• Carry Dolby Digital and DTS surround sound digitally
• Make hookup quick and easy because audio, video, and control signals are carried by a single cable
• Keep the rear of your equipment neat and tidy because there's less cabling

Connecting to a TV

HDMI cable
• Some TVs support only 2-channel PCM audio.
• If there's no sound, try changing the following set-
tings:
1.
Change the Digital/HDMI Audio Out setting to
PCM.
Audio
Digital/HDMI Audio Out
Linear PCM Out
Dynamic Range Control
2.
Change the Linear PCM Out setting to Down
Sample On.
Audio
Digital/HDMI Audio Out
Linear PCM Out
Dynamic Range Control
Signal flow
HDMI
IN HDTV,
projector
All
√ PCM
Off
√ Down Sample On
Down Sample Off

Connecting to an AV Receiver

HDMI cable
Don't forget to make the necessary settings on your
AV receiver, including:
• HDMI video input and output settings
• HDMI audio input and output settings
• Input source settings (i.e., is the HDMI IN assigned to
the DVD input source?)
Refer to your AV receiver's instruction manual for
details.
After the DV-CP706 and the other component have
been turned on and an HDMI link established
between them, "HDMI OUT" will appear on the
display. While the link is being established, "HDMI
OUT" will flash on the display. If a link cannot be
established (e.g., the HDMI cable is disconnected or
the other component is not turned on), "HDMI
STDBY" will appear on the display.
Signal flow
HDMI
IN
AV receiver
HDMI
HDMI
IN HDTV,
projector
E
n