Samsung series 5+ 550 User Manual page 15

Network Connection - Wired
There are two main ways to connect your TV to your network using cable, depending on your network setup. They are
illustrated below:
The Modem Port on the Wall
Modem Cable (Not Supplied)
The Modem Port on the Wall
✎
A network speed of lower of than 10 Mbps is not supported.
Configuring the Network Connection - Wired
Most home networks use the Dynamic Host Configuration Protocol (DHCP) to configure network connections. Home networks
that support DHCP automatically provide the IP address, subnet mask, gateway, and DNS values your TV needs to access the
Internet so you don't have to enter them manually.
To configure your network connection for a network that uses DHCP,
follow these steps:
1. Connect your TV to your network as shown in one of the
illustrations above.
2. Turn on your TV, press the MENU
select Network Network Settings. The Network Settings
screen will appear.
3. Select Wired, press ENTER(, and then press ENTER( again.
4. The Network Connection screen appears, and verifies the network
connection. When the connection has been verified, the "Internet
connection successful." message appears. Network set up is
completed.
✎
If your TV cannot acquire network the connection values
automatically or if you want to set the connection manually,
select IP Settings on the network test screen. Set Internet Protocol Setup to Manual. You must enter the IP
Address, Subnet Mask, Gateway, and DNS Server manually.
✎
For more detailed information, see "Wired Network Connection" in the e-Manual.
Extternal Modem
(ADSL / VDSL / Cable TV)
LAN Cable (Not Supplied)
button on your remote, and then
(QJOLVK  
TV Rear Panel
LAN Cable (Not Supplied)
TV Rear Panel
1HWZRUN 6HWWLQJV
6HOHFW D QHWZRUN FRQQHFWLRQ W\SH
:LUHG
:LUHOHVV *HQHUDO
&RQQHFW WR WKH QHWZRUN XVLQJ /$1 FDEOH 3OHDVH PDNH VXUH
:36 3%&
WKDW WKH /$1 FDEOH LV FRQQHFWHG
2QH )RRW
&RQQHFWLRQ
✎
The displayed imange may differ depending
on the model.
8 0RYH ( (QWHU H ([LW