Get Started; Turn On; Store Radio Stations Automatically; Find The Correct Video Input Channel - Philips DCD2030 User Manual

4 Get started

Turn on

1
Press .
» The unit switches to the last selected
source.
Note
•
If no source is played within 15 minutes, the unit
switches to standby mode.
•
If no operation is performed within 15 minutes in
standby mode, the unit switches to Eco-power standby
mode.
•
Press to switch the unit to the last source when it
was turned off.
Demonstrate the unit's features
1. In the standby mode, press
ON" is displayed.
» This system's features are displayed one
by one.
• To turn off the demonstration, press
again.
Set the clock
The unit uses the 24-hour or 12-hour time
format.
1
In standby mode, press and hold PROG/
CLOCK SET for three seconds.
» "CLOCK SET" scrolls on the display.
Then the time format [24H] or [12H]
is displayed.
2
Press / to select a time format. Press
PROG/CLOCK SET to store the setting.
» The hour digits blink.
3
to set the hour. Press PROG/
Press /
CLOCK SET to store the setting.
» The minute digits blink.
EN
14
until "DEMO
4
Press PROG/CLOCK SET to confirm the
setup.
Note
•
The number key on the remote control is deactivated
in this mode.
Store radio stations
automatically
If no radio stations are stored, the unit can store
radio stations automatically.
1
Turn on the unit.
2
Press FM.
» [AUTO INSTALL -- PRESS PLAY
-- STOP CANCEL] (press
automatic installation, or press
cancel) is displayed.
3
Press .
» The unit automatically stores radio
stations with sufficient signal strength.
» After all available radio stations are
stored, the first stored radio station is
broadcast automatically.
Find the correct video input
channel
1
Turn on your unit.
2
Press DISC to select the disc source.
• Turn on the TV and switch to the
correct video-in channel.
Note
•
See the user manual of your TV for how to switch
between video-in channels.
to start
to