Download Print this page

Clarion PSWGMTK User Manual

Behindseat mount camouflage powered subwoofer

Advertisement

Quick Links

Clarion
PSWGMTK
Behind Seat Mount Camouflage Powered Subwoofer
Chevrolet S-10 I Chevrolet Full Size Pick-up Truck
Fits
'95 -
2000 Chevrolet S-10 and GMC Sonoma
'95 - '98
Chevrolet Full Size Pick-up Trucks (extended cab only)
PREPARATION
'
PARTS LIST
(QTY)
Component
Pre-Assembled
(1) Roto-Molded Subwoofer Enclosure
(1) 8", 2 Ohm Subwoofer
(1) 100W Class
"0" Amplifier
(1) Speaker Grills
(1) Foam Ring for Grille
LooseParls
(1) 17' Wire Harness w/Pigtail Style Connector
(2) Mounting Brackets
(4) 3/4" Pilot Point Wafer Phillips Head Screws
(4) 1" Self-Tapping Phillips Head Screws
(1) 1/2" Ground Screw
(1) Star Washer
Wiring:
1 Green
2 Violet/Black
3 Green/Black
4 Violet
5 Blank
6 Black
7 BluelWhite
8 Yellow
OVERVIEW
The Clarion Camouflage subwoofer system provides for the installation of a low frequency driver in an enclosure which is
powered by a small low current, high power class "0" (Digital) amplifier The advantage to using this type of amplifier is in the
low current consumption of the amplifier at high power levels The class "0" amplifier pl\)vided with this system will produce a
rated 100W into a 2 ohm load The woofer supplied with this system uses a voice coil with rated impedance of 2 ohms, and
therefore is not considered a standard woofer Replacing the woofer with any driver having an ;mpedance greater than 2 ohms
will yield lower power output from the amplifier, and is not recommended
PROCEDURE
Proper installation of this product requires proper tools and knowledge of car audio principles If you are not comfortable performing any
of the outlined tasks below, contact a professional installation facility to perform the work
OUTLINE
• Remove the head unit
- Connect the Clarion "T" harness between the radio and factory wiring and route the harness in the vehicle
• Install mounting brackets onto subwoofer enclosure
- Test subwoofer enclosure and head unit functions (fade, balance, etc)
- Adjust subwoofer gain
• Install the enclosure
• Re-assemble the vehicle
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS.
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY
CAUSE UNDESIRED OPERATION
- 1 -

Advertisement

loading