Reset The Network Camera - Plustek Network Camera User Manual

4 DC Power Output Terminal
+12v DC, Maximum of 100mA load driver is possible.
Circuit Diagram Example
•
•
Attention

Reset the Network Camera

The reset function of the network camera allows you to set the network camera to its factory
default settings.
To reset the network camera, please keep your network camera connected to your network
and follow the steps:
1. Unload the lens cover by gently rotating counter-clockwise.
2. Insert the reset pin into the reset hole on the base of the network camera.
3. Stab the reset button with the pin
Serious damage to network camera may result if a device is
connected to the external I/O that exceeds its electrical capability.
The low voltage/current circuits and high voltage/current circuits are
in the network camera circuit. Incorrect wiring could damage
network camera.
for 5 seconds.
43