MULTIQUIP Mikasa MVH508DZ Operation And Parts Manual page 26

MACHINE INSPECTION
Perform machine inspection as listed in Table 6.
Table 6. Machine Inspection
Interval
Fuel Tank For Leaks
Fuel System for Leaks
Air Cleaner Element
Guard Frame
Daily Before Starting
Shock Absorber
Hydraulic pump
Hydraulic Pipe System
Direction Control Lever
Every 20 Hours Engine Oil/Oil Filter
Engine Oil Filter
Every 100 Hours
Battery Terminal
Every 200 hours
Every 300 hours
Engine Oil Filter
Every 2 years
PAGE 26 — MVH508DZ PLATE COMPACTOR • OPERATION AND PARTS MANUAL — REV. #0 (04/04/14)
Check Solution
Machine Clean if necessary.
Repair fuel leaks.
Repair fuel leaks.
Engine Oil Add oil if necessary.
Vibrator Oil Add oil if necessary.
Clean/Replace
Inspect/deformations
Replace if damaged.
Check/Repair Leaks
Check/Repair leaks,
Inspect for wear
Check bolts/nuts,
Inspect for wear
Check for crack/
Duct Hose
damage
Replace only after
first 20 hrs.
Engine Oil Change
Wash
Check oil level.
Vibrator Oil
Check for leaks/dirt.
Check oil level.
Hydraulic Oil
Check for leaks.
Clean
Inspect, replace if
V-Belt
damaged or worn.
Inspect, replace if not
Clutch
working properly.
Replace bolts
Engine Bolts if deformed or
elongated.
Vibrator Oil Change
Fuel Filter Change
Hydraulic Oil Change
Change
Fuel Lines Replace
TIGHTENING TORQUE
Reference Table 7 below (Tightening Torque ), for retight-
ening of nuts and bolts.
Table 7. Tightening Torque (in. kg/cm Diameter)
Material
6mm 8mm 10mm
4T 70 150 300
6-8T 100 250 500
11T 150 400 800
*
100 (6mm) 300 ~ 350 (8mm) 650 ~ 700 (10mm)
**
In case counter-part is of aluminum
Bolt threads used with this machine are all right handed
Material and quality of material is marked on each bolt, and screw.
ENGINE AIR CLEANER
DANGER
DO NOT use gasoline or low flash point
solvents for cleaning the air cleaner. The
possibility exists of fire or explosion which
can cause damage to the equipment and
severe bodily harm or even DEATH!
CAUTION
Wear protective equipment such as
approved safety glasses or face shields
and dust masks or respirators when
cleaning air filters with compressed air.
This engine is equipped with a replaceable, high-density
paper air cleaner element. See (Figure 21) for air cleaner
components.
1. Remove the air cleaner cover and foam filter element.
2. Tap the paper filter element several times on a hard
surface to remove dirt, or blow compressed air not
exceeding 30 psi (207 kPa, 2.1 kgf/cm
filter element from the inside out. NEVER brush off
dirt. Brushing will force dirt into the fibers. Replace the
paper filter element if it is excessively dirty.
MAINTENANCE
12mm 14mm 16mm 18mm
500 750 1,100 1,400
800 1,300 2,000 2,700
1,200 2,000 2,900 4,200
) through the
2
20mm
2,000
3,800
5,600