Cleaning The Unit's Exterior; Cleaning The Pickup Lens; Problems With Condensation; Moving The System Unit - RCA DVD/CD Receiver Speaker System Owner's Manual

Cleaning the Unit's Exterior

• Use a polishing cloth or dry cloth to wipe
off dust and dirt. If the surfaces are very
dirty, wipe with a soft cloth dipped in
some neutral cleanser diluted five or six
times with water and wrung out well, then
wipe again with a dry cloth.
• Do not use furniture wax or cleaners.
Never use thinners, benzine or insecticide
sprays or other chemicals on or near this
unit since they will corrode the surfaces.
• If you use a chemical-impregnated
cleaning cloth, read the instructions
carefully before use.
• Unplug the unit when cleaning.

Cleaning the Pickup Lens

The DVD player's lens should not become
dirty in normal use, but if for some reason it
should malfunction due to dust or dirt, take
it to your local RadioShack store for
servicing. Although lens cleaners are
commercially available, we do not
recommend using them since some may
damage the lens.

Problems with Condensation

Condensation may form inside the system
unit if it is brought into a warm room from
outside, or if the temperature of the room
rises quickly. Although the condensation will
not damage the system, it may temporarily
impair its performance. For this reason you
should leave it to adjust to the warmer
temperature for about an hour before
switching on and using.

Moving the System Unit

If you need to move the main system unit,
first remove all discs, then press
the front panel to turn the system off. Wait
for to disappear from the display,
Good Bye
then unplug the power cable. Never lift or
move the system unit during playback—
discs rotate at a high speed and may be
damaged.
Additional Information
Note:
Unplugging the system before
disappears from the display may cause the
system to return to the factory settings.

Radio Wave Caution

To prevent noise or interrupted
communication, do not use this system in the
following locations:
• Locations exposed to the magnetic field,
static electricity or radio wave interference
from radio communication equipment
using the same frequency band (2.4 GHz)
as this system, such as a Bluetooth device,
radio LAN device or microwave oven.
(The radio wave may not reach in certain
environments.)
• Locations near a radio. (This may cause
noise interference.)
• If the transmitter is used near A/V
equipment with an antenna input
terminal, such as a TV, VCR, BS tuner or
CS tuner, you may experience "horizontal
stripe noise on the video received on the
receiver" or "noise interference on a TV
near the transmitter". In such cases, place
the transmitter at a larger distance from
the antenna input terminal of the A/V
equipment.

Scope of Operation

Use of this equipment is limited to home use.
(Transmission distances may be reduced
depending on communication
environments.)
In the following locations, poor condition or
inability to receive radio waves may cause the
audio to be interrupted or stopped:
• In reinforced concrete buildings or homes
on
POWER
made of metallic structural members.
• Near large metallic furniture.
• In a crowd of people or near a building or
obstacle.
Good Bye
77