Recording - Philips FW545 Manual

Notes:
– Only å å å å å or ∂ ∂ ∂
∂ ∂ mode is available
during recording.
– During recording, it is not possible to
listen to another source.
Dubbing tapes
(from tape deck 1 to
tape deck 2)
1 Press TAPE ( TAPE 1•2 ) to select tape
deck 2.
2 Load the prerecorded tape into tape
deck 1 and a blank tape into tape deck
2.
™ Make sure the tape in tape deck 1
has its full spool to the left.
3 (For Tape Deck 2 only)
Press SIDE on the remote control to
select the recording side.
4 Press DUB (HSD) once for normal
speed dubbing or twice (within 2
seconds) for high speed dubbing.
™ "NORMAL" (normal speed) or
"FAST" (high speed) will be
displayed, followed by
"DUBBING".
™ The flag appears on the display
HSD
during high speed dubbing.
• Dubbing will start immediately.
™ The flag starts flashing.
REC
5 Press Ç to stop dubbing.
Untitled-13 21
Notes:
– At the end of side A, flip the tapes to
side B and repeat the procedure.
– Dubbing of tapes is only possible from
tape deck 1 to tape deck 2.
– To ensure good dubbing, use tapes of
the same length.
– During high speed dubbing in Tape
mode, the sound is reduced to a low
volume.
– You can listen to another source while
dubbing.
Recording the mixed sound /
One Touch Recording
• During microphone mixing, you can
record the mixed sound on a tape in
tape deck 2 except dubbing mode.
• For One Touch Recording, as soon as you
press REC, the current source (CD,
TUNER or AUX) will be recorded on tape
deck 2
1 Load a blank tape in tape deck 2.
2 Press REC to start recording.
™ The flag starts flashing.
REC
3 Press Ç to stop recording.
Note:
– When you press RECORD while in TAPE
mode, " SELECT SOURCE " will be
displayed. One Touch Recording is not
possible in TAPE mode.
Digital Recording via Digital
Out
For CD digital recording, please refer to the
Instructions Manual of the CD Recorder,
digital audio equipment, etc.
6/15/00, 1:16 PM

RECORDING

21
3139 116 18533