Table of Contents
Advertisement
Edge groomer
replacement
When to replace
The edge groomers, located on both
sides of the nozzle, should be re p l a c e d
when they no longer extend past the sur-
face of the bottom plate.
What to buy
When purchasing edge groomers, ask for
Hoover p a rt n o . 3 9 5 1 1 0 0 4 .
How to replace
Disconnect cleaner from electrical
outlet.
1. Remove hood and b rush ro l l cover as
shown in Figs. 3-9 to 3-12.
3 - 2 2
2. Unscrew the two Philips screws and
remove belt guard (B).
3 - 2 5
7. Replace belt guard (B) making sure
not to pinch brush bristles in guard.
Turn agitator, making sure it rotates
freely.
Replace and tighten screws.
3 - 2 0
G
2. Pull off both old edge groomers (G).
3.Push each new groomer onto the 3
tabs (H), starting with one of the end
tabs. Then push the groomer onto the
middle and remaining end tab.
4. Replace brush roll cover and hood as
shown in Figs. 3-16 and 3-17.
3 - 2 3
B
C
3. Remove agitator including end plates
(C) and discard.
4. Inspect belt to ensure that it is in
good condition. If belt is cracked,
gouged or broken, replace it (see follow-
ing section).
5. Insert brush roll through belt and
position belt over gear teeth (D) on
brush roll.
3 - 2 6
B
A
8. To replace bottom plate (A), insert the
four tabs on edge of bottom plate into
slots on front of tool.
Pivot bottom plate down and snap
closed.
H
D
Powered hand tool
Agitator brush roll
replacement
When agitator brush roll brushes are
worn, the brush roll should be replaced.
Ask for HOOVER part no. 48414088.
3 - 2 1
How to replace
Disconnect cleaner from electrical
outlet.
1. Remove tool from hose and turn it so
bottom faces up. Press the latches on
either side of tool and remove bottom
plate (A).
3 - 2 4
C
6. With curved ends down, slide end
plates (C) of brush roll into slots (E) on
tool.
A
E
11
Advertisement
Table of Contents
