Panasonic Viera TH-L32X20Z Operating Instructions Manual page 54

FAQs
Problem
Chaotic image, noisy
No image can be displayed
Blurry or distorted image
(no sound or low volume)
Unusual image is displayed
"Shop" appears on screen
at switch on
No sound is produced
Sound level is low
or sound is distorted
Sound is unusual
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
Due to the digital reception technologies involved, quality of the Digital TV signals may be
relatively low in some cases, despite good reception of Analogue TV channels.
Unable to receive signals
with a high-performance
aerial
Interference or
frozen / disappearing
image in Digital TV
TV goes into Standby
mode
The remote control does
not work or is intermittent
54
●
Change the setting of "P-NR" in the Picture Menu (to remove
noise) (p. 24).
●
Check nearby electrical products (car, motorcycle,
fluorescent lamp).
●
Is "Colour" or "Contrast" in the Picture Menu set to the
minimum? (p. 24)
●
Reset channels (p. 30, 31).
●
Turn off the TV with Mains power On / Off switch, then turn
it on again.
●
"Shop" was selected in "Auto Tuning" (p. 12).
●
Reset all settings in "Shipping Condition" (p. 34), then select
"Home" in "Auto Tuning" (p. 12).
●
Is "Sound Mute" active? (p. 10)
●
Is the volume set to the minimum?
●
Sound signal reception may be deteriorated.
●
Set "MPX" in the Sound Menu to "Mono" (p. 25).
●
Set the sound setting of the connected equipment to "2ch
L.PCM".
●
Check the "HDMI1 / 2 / 3 Input" setting in the Sound Menu
(p. 26).
●
If digital sound connection has a problem, select analogue
sound connection (p. 49).
●
Is the HDMI cable connected properly? (p. 41, 46, 47)
●
Turn Off the TV and equipment, then turn them On again.
●
Check an input signal from the equipment (p. 50).
●
Use an equipment compliant with EIA/CEA-861/861B.
●
Install an aerial individually for the TV and VCR
(or use a splitter).
TV
Aerial Output
Aerial
Input
Aerial Output
terminal
VCR
●
Check "Digital TV Signal Condition" (p. 30).
If "Signal Quality" or "Signal Strength" are displayed in
red, check aerial. If problem persists, consult your local
Panasonic dealer.
●
Turn the TV off with the Mains power On / Off switch, then
turn it On again.
●
Off Timer function is activated.
●
Auto power standby function is activated.
●
The TV enters Standby mode about 30 mins. after analogue
broadcasting ends.
●
Are the batteries installed correctly? (p. 3)
●
Has the TV been switched On?
●
Point the remote control directly at the front of the TV (within
about 7 m and a 30 degree angle of the front of the TV).
●
Situate the TV away from sunshine or other sources of bright
light not to shine on the TV's remote control signal receiver.
Actions
(Individual aerial)
Splitter
Aerial Input
(Individual aerial)