Removing, Reversing And Replacing Doors - Kenmore 795.6900 Series Use & Care Manual

REMOVING,REVERSING AND REPLACING
REFRIGERATOR DOORS (For Freezer Drawer Models)
Before you begin, either unplug the refrigerator or turn
off power at the circuit breaker or fuse box. Failure to
do so could result in death or serious injury.
Remove food and any Adjustable Door or Utility Bins
from doors. Failure to do so could result in serious
injury.
10mm or
13
32
Adjustable wrench
screwdriver and remove.
Fig. 25
Using 10mm or 13 -inch socket wrench, remove
32
the 3 bolts and lift off the Top Hinge. Set parts aside.
Fig. 26
Lift up refrigerator door slightly and remove it.
Fig. 27
Hinge Pin
REFRIGERATOR INSTALLATION
-inch socket wrench
Remove Hinge Pin Insert on the right side of the
door and reinstall on left side.
Fig. 28
Hinge Pin
Insert
Turn refrigerator door upside down on a non-scratch
surface.
Loosen the 2 screws to remove the Bottom Hinge
Pin Insert Bracket with Hinge Pin Insert.
Fig. 29
Hinge Pin
Insert Bracket
Remove screw on the opposite side of the door.
This screw is no longer necessary and can be
discarted.
Move the Hinge Pin Insert Bracket to the other side
of the door, keeping the same orientation, and push
the Hinge Pin Insert into the hole on the left side of
the bracket. Insert the 2 screws as shown below.
Fig.30
uncover screw holes and place it on the right side.
Fig. 31
13
Hinge Pin
Insert