Cabinet Disassembly Instructions - Sylvania SSC132 Service Manual

CABINET DISASSEMBLY INSTRUCTIONS

1. Disassembly Flowchart
This flowchart indicates the disassembly steps for the
cabinet parts, and the CBA in order to gain access to
item(s) to be serviced. When reassembling, follow the
steps in reverse order. Bend, route and dress the
cables as they were.
Caution !!
When removing the CRT, be sure to discharge the
Anode Lead of the CRT with the CRT Ground Wire
before removing the Anode Cap.
[1] Rear Cabinet
[2] Tray Chassis
[3] Deck Unit
[4] Main CBA
[5] CRT
2. Disassembly Method
ID/
LOC. PART
Fig.
No.
No.
Rear
[1] 1, 2 4(S-1)
Cabinet
Tray
[2] 3, 5
Chassis
[3] Deck Unit 3, 5
[4] Main CBA 3, 5 6(S-4)
[5] CRT 4
↓ ↓ ↓
(1) (2) (3)
REMOVAL
REMOVE/
*UNHOOK/
UNLOCK/RELEASE/ Note
UNPLUG/DESOL-
DER
1
Anode Cap, CN501,
CRT CBA, CN601, 2
CN802, CN571
7(S-2), 2(S-3),
Desolder (CL201,
3
CL401, CL402,
CL403)
4
4(S-5) 5
↓ ↓
(4) (5)
(1): Order of steps in Procedure. When reassembling,
follow the steps in reverse order.These numbers
are also used as the identification (location) No. of
parts in Figures.
(2): Parts to be removed or installed.
(3): Fig. No. showing Procedure of Part Location.
(4): Identification of part to be removed, unhooked,
unlocked, released, unplugged, unclamped, or
desoldered.
S=Screw, P=Spring, L=Locking Tab, CN=Connec-
tor, *=Unhook, Unlock, Release, Unplug, or Desol-
der
2(S-2) = two Screw (S-2)
(5): Refer to the following "Reference Notes in the
Table."
Reference Notes in the Table
1. Removal of the Rear Cabinet.
Remove Screws 4(S-1).
Caution !!
Discharge the Anode Lead of the CRT with the CRT
Ground Wire before removing the Anode Cap.
2. Removal of the Tray Chassis.
Discharge the Anode Lead of the CRT with the
CRT Ground before removing the Anode Cap.
Disconnect the following: Anode Cap, CN501, CRT
CBA, CN601, CN571 and CN802. Then, pull the
Tray Chassis backward.
3. Removal of the Deck Unit.
Remove Screws 7(S-2) and 2(S-3). Then, desolder
connectors (CL201, CL401, CL402, CL403) and lift
up the Deck Unit.
4. Removal of the Main CBA.
Remove Screws 6(S-4) and pull up the Main CBA.
5. Removal of the CRT.
Remove Screws 4(S-5) and pull the CRT back-
ward.
1-6-1 T5304DC