Installing Or Removing The Hard Disk Drive Assembly - Lenovo 10AX User Manual

6. Slide the computer cover to the front of the computer a small amount. Then, lift the computer cover to
remove it from the computer.
Figure 39. Removing the computer cover

Installing or removing the hard disk drive assembly

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page v.
This section provides instructions on how to install or remove the hard disk drive assembly.
To remove the hard disk drive assembly, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 51.
3. Locate the hard disk drive. See "Locating components" on page 12.
4. Disconnect the signal cable and the power cable from the hard disk drive.
.
Chapter 5 Installing or replacing hardware
53