Specifications - Sony CDP-D12 Specifications

SPECIFICATIONS

Outputs
Analog line outputs (L/R)
Digital outputs (IEC60958 consumer)
Optical
Coaxial
Headphone output
Audio Performance
Sampling frequency
Wow and flutter
Frequency response
Signal-to-noise ratio
Channel separation
Pitch control
Total harmonic distortion
D/A conversion
General
Laser
Applicable discs
Power requirements
Power consumption
Operating temperature
Storage temperature
Mass
Dimensions (W x H x D)
Supplied accessories
Distributed by
A-1106
MK10060V1TC03AUG
Printed in Japan on recycled paper
Phono (x 2), unbalanced, max. +8 dBu, 10 kΩ load or more
XLR-3-32 (x 2), balanced, -10 dBu (max. +10 dBu)/+4 dBu (+24 dBu) selectable, 600 Ω load or more
Square optical connector (x 1), -18 dBm, wave length: 600 mm
Phono (x 1), 0.5 Vp-p, 75 Ω load
Phone (stereo), 0 to 10 mW, 32 Ω load
44.1 kHz
Less than measurement
20 Hz to 20 kHz ±0.5 dB
98 dB or more
87 dB or more (1 kHz)
Normal speed ±12.5% in 0.5% steps
0.006% or less
24-bit, x 128 oversampling
Semiconductor laser (λ 780nm)
8 cm/12 cm CD, CD-R, CD-RW
AC 120 V, 60 Hz (UC2)
AC 220 V, 50/60 Hz (CN2)
AC 230 V, 50/60 Hz (CED)
18 W (UC2/CN2)
16 W (CED)
0 to +40 ˚C (+32 to +104 ˚F)
-20 to +60 ˚C (-4 to +140 ˚F)
4.0 kg (8 lb 13 oz)
482 x 44 x 265 mm (19 x 1 3 / x 10 1 / inches)
4 2
Remote control unit (x 1), Control-S cable (x 1), operating instructions (x 1)
©2003 Sony Corporation. All rights reserved.
Reproduction in whole or in part without written permission is prohibited.
Features, design, and specifications are subject to change without notice.
All non-metric mass and measurements are approximate.
Sony is a registered trademark of Sony Corporation.
0 dBu = 0.775 Vrms