NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
(In addition to this, the necessary note is printed in each block)
Note on Printed Wiring Board:
• X : parts extracted from the component side.
•
: internal component.
f
• b : Pattern from the side which enables seeing.
Caution:
Pattern face side:
Parts on the pattern face side seen from
(Side B)
the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Side A)
the parts face are indicated.
• Indication of transisitor.
Q
B
C E
These are omitted.
Q
B
C
E
These are omitted.
C
Q
These are omitted.
B
E
SECTION 7
DIAGRAMS
Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
specified.
•
: internal component.
f
• 2 : nonflammable resistor.
• 5 : fusible resistor.
• C : panel designation.
The components identified by mark 0 or dotted
line with mark 0 are critical for safety.
Replace only with part number specified.
• U : B+ Line.
• V : B– Line.
• H : adjustment for repair.
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F
: TUNER (FM/AM)
E
: PLAYBACK (DECK A)
d
: PLAYBACK (DECK B)
G
: RECORD
J
: CD PLAY (ANALOG OUT)
c : CD PLAY (DIGITAL OUT)
N
: MIC INPUT
• Abbreviation
AUS : Australian model
AR
: Argentine model
EA
: Saudi Arabia model
MY
: Malaysia model
MX
: Mexican model
SP
: Singapore model
1
/
W or less unless otherwise
4
19