Table of Contents
Advertisement
4. SERVICE MODE / TRIM CHECK MODE ( ENGLISH )
DISPLAY button
DISPLAY
TONE
SPEAKER
A
INPUT
SELECTOR
SPEAKER
B
1.
To enter the Service Mode, press the POWER ON/OFF button with pressing the DISPLAY and ATT buttons to turn on the
unit. Or when the remote code "166363" is received while power is ON.
When into the Service Mode, the memory is cleared and the unit is initialized.
2.
The Model name and Version number are displayed on the Front LCD.
Whenever press the DISPLAY button, the display changes as follows.
Turn off power to quit service mode.
Press
TO ENTER THE TRIM CHECK MODE.
Before press the TONE button, following connection and setup are required.
DISPLAY button
INPUT
SELECTOR
INPUT
SPEAKER A
SELECTOR
1.
Oscillator is connected to R and L of CD input terminal.
2.
Voltmeter is connected R CH+– and L CH+– of SPEAKER SYSTEMS A.
3.
Adjust out put level of Oscillator to "500 mV, 1 kHz".
4.
Turn INPUT SELECTOR knob, and select CD.
5.
Turn VOLUME knob, and adjust volume level to "-36.0 dB".
6.
Press SPEAKERS A button.
7.
Press TONE button. (1 st)
DISPLAY
ATT
INTEGRARED AMPLIFIER PM-11S1
ATT.
PRE OUT
OPERATE
REC OUT
VOLUME
POWER ON/OFF
PHONES
PHONO
MC
POWER
VOLUME
ON/OFF
Connect connector
IN and Out of F.C.B.S
Press
ALL LCD's are disappear
TONE
DISPLAY
INTEGRARED AMPLIFIER PM-11S1
DISPLAY
ATT.
TONE
PRE OUT
OPERATE
SPEAKER
A
REC OUT
POWER ON/OFF
PHONES
SPEAKER
PHONO
B
MC
POWER
ON/OFF
3
2
1
OK is displayed when there is no problem
with the communication.
Press
NG is displayed when there is problem
with the communication
Oscillator
AC Voltmeter
VOLUME
VOLUME
4
3
2
1
After 3
seconds
Press
R ch
L ch
AC Voltmeter
3
3
2
1
2
1
AC IN
CONNECT
AC IN
Hide quick links:
Advertisement
Table of Contents
